4 Inch Wall Address Numbers - Built In Hanger

4 Inch Wall Address Numbers - Built In Hanger Numbers 0 - 9 4 inch high (102mm) and 10mm thick. Easy to use hanger is built right in. Clean lines and sharp smooth curves in a modern stylish font. Hangers are perfectly even on all numbers to make hanging easier. Friction will hold them at the angle you want just use countersunk hardware and adjust it right. Tighten until the letter slides on the screw with enough resistance to create friction. (It's super easy to get the hang of - Some pun intended) You will still need some two sided tape or a little earthquake putty to make sure they hang level if you dangle it from the hardware. You can of course mount these with two sided tape instead of screws too. ONE NUMBER PER PLATE to make printing just what you need easy. Numbers print in about 30 minutes each with no support. Prints great in PLA+, PLA-CF, PETG and PETG-CF. Examples printed in Bambu Lab Matte Charcoal.

Original model by BattCave on MakerWorld: https://makerworld.com/en/models/1718338-4-inch-wall-address-numbers-built-in-hanger